Skip to main content

Choose an angled cut end wall for a full height caravan or a square cut end wall for a pop top, then check the dimensions against your awning before you order.

What Is a Caravan End Wall?

A caravan end wall (also called an end screen) is a panel of shade mesh or waterproof fabric that hangs from the end of your awning to the ground. It attaches to the awning arm at the top and pegs down at the bottom, closing the open side at the front or rear of the van.

On its own, an end wall cuts out low morning or afternoon sun, a steady breeze or the view from the next site. Paired with a long side wall, it turns the awning into a shaded outdoor room.

Full Caravan vs Pop Top End Walls

Full caravan end walls are angled cut. On a full height caravan, the awning runs from high on the van wall out to the roller bar, so the end wall is taller at the van side. Campsmart's XD full caravan end wall, for example, is 2.2 m wide and 2.40 m high at the van end, dropping to 1.95 m at the awning edge.

Pop top end walls are usually square cut, with the same height across their width, to suit the lower awning on a pop top. However, some pop tops can also use angled cut end walls with a suitable anti flap kit. Check your awning setup and the product dimensions before choosing.

End wall typeCutCampsmart sizesHow it attachesBest for
Full caravanAngledStandard: 2.1 m wide, 2.35 m to 1.9 m high. XD and waterproof: 2.2 m wide, 2.40 m to 1.95 m highVelcro straps, 6 mm keder rope, pegs and ropesFull height caravans with a roll out awning
Pop topSquare2.1 m wide. XD: 1950 mm dropVelcro straps (XD also has 6 mm keder rope), pegs and ropesPop tops with a roll out awning

Which Caravan End Wall Range Is Right for You?

There's no single best range. It depends on how tall your van sits and whether you want airflow or rain protection.

RangeWhat it's forKeep in mind
Standard (grey or black)Shade, privacy and airflow at a lower priceShorter drop than XD, so it may leave a gap at the base on taller vans
XD end wallsA 1950 mm drop and, on full caravan versions, a 2.2 m width for greater shade coverage than standard end wallsShade mesh won't keep rain out
Waterproof end wallsPU coated Oxford polyester to keep rain out. Lighter and more compact than canvas wallsDoesn't let the breeze through the way mesh does
XD dual layer end wallsCombines a black mesh layer for shade and airflow with a waterproof grey Oxford fabric layer for rain protection. Use either layer depending on the weather, or both for added privacySold as separate front and rear versions, so check which end you need

A black caravan end wall gives more privacy than grey mesh and suits vans with black graphics or checker plate.

How to Choose and Check the Fit

Awning type

These end walls are designed for roll out awnings, and Campsmart lists them for Carefree Fiesta, Dometic, A&E and Sunburst roll outs. They aren't designed for box (cassette) awnings. If you have a bag awning or another setup, check with the team before ordering.

Caravan or pop top

Full height caravans generally use angled cut end walls, while pop tops usually use square cut versions. Some pop tops can also accommodate angled cut end walls with a compatible anti flap kit.

Front or rear

Standard shade mesh and single layer waterproof end walls can be fitted at either end of your awning. XD dual layer end walls are different, with separate front and rear versions. Check which end you need before ordering.

Size

Set the awning up at your usual camp height, then measure:

  • Width: from the van wall to the roller bar. Many end walls are 2.1 m wide, which suits smaller awnings but can be a little short on full size caravans.
  • Height: from the ground to the awning at the outer edge and, on a full caravan, at the van wall.

Compare both with the product page dimensions. If your van sits high, as many off road vans do, an XD end wall's extra drop helps it reach the ground.

Attachment point

Campsmart's end walls have Velcro straps that wrap around the awning arm. Most also have 6 mm keder rope, a cord sewn into the top edge that slides into an anti flap kit for roll out awnings or the awning's sail track for a neater top edge. If you plan to use keder rope, check the product includes it.

Not sure which end wall fits? Check the dimensions on the product page or ask the Campsmart team.

How to Fit a Caravan End Wall

  1. Set up the awning and its legs.
  2. Wrap the Velcro straps around the awning arm, or slide the keder rope into your anti flap kit.
  3. Peg the base through the D rings and eyelets with the supplied pegs and ropes, tensioning evenly.
  4. Check the tension again after any wind.

An end wall catches wind like a sail and adds load to your awning. Follow the product instructions, keep it pegged and roped, and take it down before strong wind. Spare ropes, poles and pegs are worth carrying.

Using End Walls with Long Side Walls

Add a long side caravan sunshade along the front of the awning and you have a more enclosed, shaded space. XD end walls share the 1950 mm drop of the long walls in Campsmart's XD privacy screens range, so the bottom edges line up, and buying from the same range keeps grey shades consistent. Size your long wall with the privacy screen size guide, or browse all caravan end walls.

Frequently Asked Questions

What is the difference between a caravan end wall and a pop top end wall?

A full caravan end wall is angled cut, taller at the van side, to follow the awning on a full height caravan. Pop top end walls are usually square cut for a lower awning, although some pop tops can also use angled cut versions with a suitable anti flap kit.

What size end wall do I need?

Measure the distance from the van wall to the roller bar and the height from the ground to the awning, then compare these with the width and drop on the product page. Taller and off road vans usually need an XD end wall's 1950 mm drop to reach the ground.

How do caravan end walls attach?

Velcro straps wrap around the awning arm, and the base is pegged through D rings and eyelets with the supplied pegs and ropes. Most Campsmart end walls also have 6 mm keder rope for an anti flap kit or sail track.

Do caravan end walls fit box awnings?

Generally, no. These end walls are designed for roll out awnings. If you have a Fiamma F45 with the Fiamma Fast Clip System, Campsmart sells a dedicated F45 end wall. It doesn't suit an F45 without that system.

Are caravan end walls waterproof?

It depends on the range. Standard and XD end walls are shade mesh for sun, wind and privacy, and they'll let rain through. If you need a waterproof caravan end wall, choose the waterproof or XD dual layer range, both made to keep rain out.

Can I return an end wall if it doesn't fit?

Campsmart's returns policy excludes awning and annexe walls from change of mind returns, so it's important to check your measurements before ordering. If your end wall is faulty, your rights under Australian Consumer Law still apply, alongside any applicable product warranty.

Find the Right End Wall for Your Van

Match the shape to your van, check the width and drop against your measurements, then choose the range that suits the way you camp. Still unsure? The Campsmart team can help you narrow it down before you order.

Footer