50L Grey Water Tank

The new 50L Universal Tank has extra large 40mm threaded female closers to suit grey water solutions, but given the tank is also made from food contact approved plastic, it can also suit freshwater applications. The 50L tank can be configured in many ways to provide a single low cost solution to your greywater or freshwater storage requirements.

The tank is made from food contact approved High Molecular Weight High Density Polyethylene. This makes the tank a super tough performer. 

The tank is moulded with two integral 40mm (1.5” BSP) threaded female closures that can accept a wide variety of standard fixtures and fittings. Using these standard fittings the tank can be networked together to provide many water storage options for your RV.

Fitting Guide:

• Install the tank in one of the configurations shown in the diagram to provide the optimal installation for your application. 
• Use Teflon sealant tape on fittings and ensure they are not cross threaded. Tanks should be fully supported with no load on fittings. Tank may swell when full.
• When installation configuration has been chosen, drill a 3-4mm hole in the top of each tank to allow for air venting

Please note fittings are not included with the tank.

Specifications & Features:

• Universal Modular Grey Water or Fresh Water Tank 50 Litre
• Made from food contact approved, high density polyethylene.
• Weight: 2.85 Kgs.
• Dimensions: 70 cm x 38 cm x 21 cm.
• Two integrated 40mm (1.5 Inch Female BSP) threaded connections can accept a wide variety of standard threaded pipe fittings.

Important:

Filling a tank under pressure can burst the tank, such damage is misuse and is not warrantable. Please seek expert advice or support if unfamiliar with fitting and filing of water tanks. It is the customers' responsibility to fit and fill the item correctly.